See Thru Gates

With the increasing danger of large cities, see through gates has become increasingly common. People have been worried about the time to get home, as this is a very popular time for burglars to approach a victim.

That is why using a see through gate is so important. With an electronic gate, the person does not need to get out of the car to open it, he can open it from a distance. Thus, the exposure time is shorter, since in a manual gate, it is necessary to get out of the car to open it and, after stopping, it is necessary to go back to close it.

With an automatic gate, the person can open and close with a remote control, thus reducing the time that it remains open.

Automation of see through gates is an investment with a great cost benefit

If you want to automate gates in your garage or in the garage of your building, count on quality and experience. We have trained professionals to inform you what the best mechanism is to be installed at your gate. We are specialists in offering the best services in all models of gates and gates, automation, maintenance and regular service.

When you get up, the leaf of the see through gate is a little bit of the gate inside and a little bit of the gate outside the garage, the gate does not take space from the vehicle inside because the gate advances over the car.

Being well balanced the see through gate is a very resistant device, as the gate is raised by two counterweights, one on each side of the gate, being raised by the counterweights, the gate rises without vibration. The tilting gates are made with a torsion bar that is a structural element, bearings at the ends of the gate and in cases of very wide gates, with a bearing in the center of the gate for support.

When the automatic gate goes up the see through gate is pulled by the steel cables, the torsion bar acts as a balancing element for the movement of the gate. Each centimeter raised on one side of the gate corresponds to the same elevation on the opposite side of the gate in such a way that the gate rises evenly. The gate must never go up twisted or with efforts that could compromise its useful life.

The see through gate works powered by a motor-reducer group that, by means of a gear, pushes a rack ruler attached to the gate in such a way that the gate moves by closing or opening, depending on the direction of rotation of the motor, which is reversible.

The see through gate is simpler to install, although it has to be very well aligned. This alignment work is judicious and if not done accurately it can compromise the entire life of the machine and, therefore, of the gate.

Usually the existing see through gates, which were not prepared for automation, are very heavy, as it does not take into account the service performed by the engine, but by the hand of man. But as time goes by, these gates start to get heavy, compromising the life of the engine, the electronic control unit and all the internal parts of the gearbox. When the gate is automated, the engine adds a mechanical strain on the gate, greater than the effort exerted by manual opening. It starts by burning the control center, which is over-requested with an extra load of electric current. It ends up destroying the mechanisms of the motor reducer and its own electrical winding.

When we are going to automate a gate that has been operating for a long time without automation, before we automate this gate, we do a complete overhaul of it. If necessary, we add new casters, a new rail, guides and stops. On this occasion, the gate is fully aligned.